Page 1 of 1

CS9320 NAVIGATION BOX

PostPosted: 29 Apr 2014, 14:59
by FISHERMAN
Dear, friends

I see that you have annouced a new model CS9320. Is this model compatible with my ALPINE IVA D310 monitor?

I am using this monitor and touch capabilities with a CS9100 for a very long time and i would like to upgrade.

Do i need another set of cables or i can just unplug CS9100 and plug CS9320.

Thanks in advance

Re: CS9320 NAVIGATION BOX

PostPosted: 30 Apr 2014, 11:12
by Chortenia
Hello!
CS9320 has the same protocols as CS9200/9900, so it should work with ALPINE IVA D310.
You can find ALPINE compatibility list here.

Best regards,
Car Solutions Team

Re: CS9320 NAVIGATION BOX

PostPosted: 14 May 2014, 10:18
by Tagchen
Hi,

I will use the CS9320 on Kenwood KVT-827(DVD). My Question, how must connect the touchpanel with CS9320?
Connect the Kenwood with the cable KEN-RGB1 same as CS9200??

Thanks

Re: CS9320 NAVIGATION BOX

PostPosted: 16 May 2014, 11:04
by Chortenia
Hello.

Yes, connect it with the Kenwood cable and select Kenwood protocol in CS9320 settings.

Best regards,
Car Solutions Team

Re: CS9320 NAVIGATION BOX

PostPosted: 26 Sep 2014, 00:21
by rolchg
What is the minimal cable connection to perform
test out of a car?
Is it enough to connect:
1. yellow (BATT+) (permanent +12V)
2. red (CAR_ACC_IN): +12V after switch (ON/OFF)
3. black (GND): ground (-12V)
4. CVBS to monitor
5. GPS antena
6. USB mouse
or additional connections to "data" cable are necessary?