Car Solutions Forums

Does iGO Primo 2.4 doe Win CE6.0 works with CS9200RV ?
The Navy software support the 800x480 map resolution but from the manual is not 100% clear if CS9200RV can read them.

In case IGO Primo 2.4 is a suitable software, could you please tell me how to configure the following in CS9200RV:

RGB ADJUST:
My ideea is the following:
...
H - Size: 480
...

CVBS ADJUST:
My ideea is the following:
PAL - BDGHI (I'm using the system in Italy)
Width: 800
Height: 480
...

PANEL
My ideea is the following:
4 pin touch
Select -> 800x480

RESOLUTION
Select -> 800x480

lease find attached the connection scheme.

Thank you
Best Regards,
Antonello

Hello!

The CS9200 supports resolution up to 800х480.
We didn't install IGO Primo, however, we can help you with IGO 8.3.

Best regards,
Car Solutions Team

Thank you.

Could you also please tell me if the proposed configuration in CS9200RV, in principle, are correct ?

Thank you
Best Regards,
Antonello

The configuration is not correct for your case. You will use USB touch screen adapter, so the protocol should be not 4 pin touch, but eeti usb touch. As far as connection scheme is concerned, the CS9200 has RGB output and the interface has the input. It’s better to connect them in such way since the image via the composite output will be much worse.